Clear Wood Preserver
Ronseal Clear Wood Preserver's colourless formulation is designed specially to give wood long lasting protection against decay before painting, staining or varnishing. It is low odour, fast drying, and safe near plants and pets when dry.
Colours Available:
WHERE CAN I USE IT
Ronseal Clear Wood Preserver is recommended for the preservation of interior and exterior wood such as floorboards, joists, window frames, doors, sheds and fences, etc
WHAT SORT OF FINISH
n/a
HOW MANY COATS
2-3 coats recommended.
COVERAGE
Approximately 4-8m² dependent on the type of substrate please refer to back of pack for specific guidance on application.
DRYING TIMES
Allow 2-3 hours between coats
APPLICATION
Ensure wood is clean and dry. Finishes such as paint, stain and varnish must be completely removed. For rough sawn wood, use a stiff brush to remove dirt, moss, fungal growth and lichens. Weathered wood should be sanded to remove loose wood fibres leaving sound surface. Shake well before use. Apply liberally to all surfaces. 2-3 coats should be used. Allow 2-3 hours between coats. Apply to any surface cut after treatment. After thorough drying, glues, fillers and mastics maybe used, and floor or wall coverings can be laid / hung. Where required, finishing products (paint, stains, varnish or polishes) maybe applied once the product is thoroughly dry.
CLEAN UP AND MAINTENANCE
Remove as much product from the brush as possible before cleaning with water and detergent. Do not empty into drains or watercourses. Some local authorities have special facilities for disposing of waste coatings.
Ronseal - Home
| 
